Roofing Company in Belterra, TX

Replacing a Belterra roof means a 2005 to 2012 builder roof coming off a two-story home: full tear-off, synthetic underlayment, ice and water shield in every valley, flashing rebuilt, ventilation sized right, and a Class 4 shingle or standing seam nailed and sealed for Hill Country wind, in an HOA-approved color.

Shingle roofing in Belterra is Class 4 architectural shingles in the HOA-approved colors, installed with six nails per shingle, sealed starter and rake edges, and real ventilation, because the exposure here punishes anything less.

Standing seam is increasingly the choice on Belterra replacements: it does not lift in wind, shrugs off hail, and suits the Hill Country style. We install it with the right underlayment and price it against a Class 4 shingle.

New construction roofing in Belterra is the last phases still building, additions and outdoor living structures. We tie additions into the existing roof properly and match the HOA rules on material and color.

Free inspections in Belterra are mostly after storms and before home sales. We walk every slope, check the attic and the flashing, and give you photos and a plain answer.

Belterra roof repair is wind repair first: creased and missing shingles on the exposed slopes, ridge caps gone, and wall flashing that wind-driven rain got under. We replace and hand-seal, nail for wind, and match the shingle so it disappears into the roof.

Belterra leaks usually show up after a windy rain, not a still one, which points to wall flashing, a dead valley or a lifted course rather than the field of the roof. We trace it from the attic and fix the entry point.

When hail crosses Belterra it hits the whole community at once and the door knockers follow. We inspect every slope, photograph bruising with the storm date, and tell you honestly whether it is a claim, a repair or nothing.

Wind damage is the most common Belterra call. We walk every slope, replace what is creased or gone, hand-seal what lifted, re-nail for wind, and document it for a claim when a whole slope is affected.

A section of shingles gone in a Belterra windstorm gets tarped at first safe light, photographed for your carrier, and repaired nailed for wind once it is dry.

Belterra claims are hail and wind on homes that were all built in the same window, so the adjuster has seen the neighbor's roof already. We document yours slope by slope, meet the adjuster, and build to the approved scope with the HOA submission handled.

Flat and low-slope roofs for shops, offices, retail and warehouses.

• TPO and single-ply membrane installation and replacement
• Flat roof repair: seams, drains, curbs, penetrations and ponding areas
• Metal roof retrofit for commercial and ag buildings
• Modified bitumen and built-up roof repair

Single-ply membrane for flat and low-slope roofs, commercial and residential.

• New TPO installation on flat and low-slope roofs
• TPO replacement, including wet insulation removal
• TPO repair: seams, flashings, drains and punctures
• Low-slope sections on homes: porches, additions and flat roofs

Seams, drains, ponding and flashings on low-slope roofs, homes and small commercial.

• TPO, modified bitumen, EPDM and built-up roof repair
• Seam repair and rewelding
• Drain, scupper and gutter flashing repair
• Ponding area correction

Standing seam and R-panel for shops, warehouses, churches and ag buildings.

• Standing seam metal roofs for commercial and ag buildings
• R-panel and PBR-panel roofs
• Metal-over-metal retrofit on sub-purlins
• Metal-over-flat retrofit with slope-build framing

A written condition report with cores, photos and options, per building.

• Roof walk with photo mapping of every defect
• Core samples for wet insulation, patched afterward
• Drain, scupper and gutter check
• Seam, flashing, curb and parapet condition